Troubleshooting - GYS Flash 70-24 HF Manual Del Usuario

When the clamps are in short circuit, the message, « Scc » disappears.
4. The result « End »: Indicates the cables are in good working condition, and will be displayed
for 10 seconds - after which the Gysflash 70-24 HF will revert back to the main menu.
5. If no message is displayed during this time, this indicates there may be an error with the
cables. After switching off the charger, clean the contacts then check the charge cables and
change them if necessary. After this is done, restart the « check cables » cycle.
Charge End / Floating mode "FLt"
After the battery has been charged, 'Floating' mode continues to deliver a current to the battery to
maintain a maximum charge.
This function is initially active => display « FLt ».
To disable this function, select « OFF ».
Restart "LP":
The automatic restart function only works in charge mode - it enables an automatic restart for the
charger in the event of unexpected power loss.
By default, the function is inactive : displays « off ».
To activate this function, select « LP » for LOOP.
PROTECTION
The Gysflash 70-24 HF is protected against short-circuits, polarity inversions and engine starts. It has
an anti-spark feature which prevents sparks whilst connecting the Gysflash 70-24HF to the battery.
The Gysflash 70-24 HF will not deliver current if there is no battery detected (no voltage in the
clamps). The charger is protected by 1 x 80A (Ref: 054651) internal fuse.

TROUBLESHOOTING

PROBLEMS
A warning beep sounds
+ the warning LED illuminates
+ the display shows :
The display shows :
+ the warning LED flashes
The display shows :
+ the warning LED flashes
The display shows:
+ The warning LED illuminates
« Bat »
« HI »
« OUt »
CAUSES
Gysflash 70-24 HF detects a
polarity reversal in the clamps.
The charger cannot detect a
battery
A consumer has been left on
(eg : Headlights)
The battery is in short circuit or
damaged.
SOLUTIONS
Connect the red clamp to the
"+" terminal, and the black
clamp to the "-" terminal
Ensure the battery terminals are
clean, and the clamps are
securely connected
Turn off any active consumers,
disconnect the clamps and re-
connect to re-start the charge
Alternatively: disconnect the
battery from the vehicle before
charging.
Replace the battery
17