Filling With Water; Before Ironing - ARIETE Vapor Plus Manual De Instrucciones

instead.
• when the iron is hot, do not rest it onto the connecting cable or the power cord. Take special care in ensuring that the cable
and the cord do not come into contact with the soleplate when it is hot.
• Do not pull the power cord to unplug the appliance.
• The appliance must only be cleaned with a soft, slightly damp cloth after unplugging the iron and allowing all its parts to
cool down. never use solvents which may damage the plastic parts.
• clean the boiler at least every three months so as to eliminate any residue of lime that could jeopardize proper
operation of the appliance.
• Do not pour vinegar, descalers or other scented substances into the tank; under penalty of immediate cancellation of the
warranty.
• Do not wrap the power cord around the soleplate when the iron is hot.
• Do not put the soleplate in contact with metal surfaces.
• The boiler cap contains a safety device (set so that it triggers in the event of excess pressure in the boiler) and must only
be replaced with an original spare part.
• To maintain the iron in good working order, disconnect the plug from the outlet at the end of every ironing session, dischar-
ge the inside pressure by fully pressing the steam push button, unscrew the safety cap and let the residual water in the
tank evaporate. empty the boiler.
• we decline any responsibility resulting from misuse or any use other than those covered in this booklet.
• This product complies with the eu electromagnetic compatibility Directive.
KEEP THESE INSTRUCTIONS IN A
•
SAFE PLACE AT ALL TIMES
Notes: when using the iron for the first time, test it on an old piece of fabric to ensure that the soleplate and the water tank
are completely clean.
DESCRIPTION OF THE APPLIANCE (FIG. A)
1 - Safety cap
2 - Steam control knob
3 - cap remover
4 - steam push button
5 - Warning light
6 - power cord
7 - Temperature regulator
8 - soleplate
9 - Boiler
10 - Separate iron base
11 - Funnel
12 - Measure

FILLING WITH WATER

- Ensure that the iron is disconnected from the power supply before filling.
- Place the iron on the stand (10) in a horizontal position and use the provided measure (12) and funnel (11) to fill the boiler.
see Fig. B
- ENSURE THAT THE AMOUNT OF WATER NEVER EXCEEDS 210 CC, which is the exact amount indicated on the mea-
sure; if the amount of water in the boiler is in excess, water may leak and/or spurt from the iron's soleplate at the beginning
of the ironing session.
- Do not fill the boiler tank with chemical additives or other perfuming or decalcification agents.
- empty the boiler after use.

BEFORE IRONING

ensure that the safety cap on the boiler is well tightened. Turn the cap until it stops and then tighten it slightly without ap-
plying too much strength to avoid breaking the gasket, which would cause the steam to leak out.