Filling The Tank; Switching On The Appliance - ARIETE Stim matic no stop Excellence 6387 Manual De Instrucciones

• Do not use sparkling (carbonated) water.
• When the iron is hot, do not rest it onto the power cord. Take special care in ensuring that the cable and the cord do not
come into contact with the soleplate when it is hot.
• Do not pull the power cord to unplug the appliance.
• The appliance must only be cleaned with a soft, slightly damped, cloth after unplugging the iron and allowing all its parts
to cool down. never use solvents which may damage the plastic parts.
• clean the boiler at least every three months so as to eliminate any residue of lime that could jeopardize proper
operation of the appliance.
• Do not pour vinegar, descalers or other scented substances into the tank; under penalty of immediate cancellation of the
warranty.
• Do not wrap the power cord around the soleplate, especially when the iron is hot.
• Do not put the soleplate in contact with metal surfaces.
• Before storing the appliance, turn it off by pressing (B) and (S) buttons, always unplug it from the mains, and allow it to
cool down before emptying the boiler completely.
• Do not expose the appliance to atmospheric agents (rain, sun ...).
• KeeP these instRuctions in a safe Place at all tiMes
DESCRIPTION OF THE APPLIANCE (FIG. 1)
A - Boiler
B - Iron on-off switch
C - Iron on-off indicator lamp
D - Cord storage device
E - Iron stand grille
F - Safety cap
G - Water measuring cup
h - Tank
I - power supply cable
l - Iron temperature control indicator light
M - Thermostat knob
n - plate
o - Steam button
p - Continuous steam button
q - Continuous steam lock slider
r - Iron/boiler connection cable
S - Boiler on-off switch
T - Boiler on-off indicator lamp
U - Manometer
V - Steam regulator
W - Boiler cap
INSTRUCTIONS FOR USE
Installation
place the appliance on an horizontal and stable surface.
For the steam ironing you can use tap water (hardness 15 French degrees max.). In the event of excessively hard water,
we suggest you use demineralised water instead. Do not add any additives, under penalty of immediate cancellation of the
warranty.

Filling the tank

lift the cap (F) and pour water into the tank while being careful to not exceed the MAX limit (Fig. 3). replace the cap.
Warning!
To avoid damage the pump, never operate the appliance without any water in the tank, even for dry ironing.

Switching on the appliance

Connect the appliance to the power supply, ensuring that the voltage indicated on the identification plate corresponds to
your local power supply.
press the boiler on-off switch (S). Turn the steam adjustment knob (V) to the desired value, and wait about eight minutes
until the steam is ready while keeping the iron on its stand. Then press the switch (B) to switch on the iron.