Kobalt KT200A Manual Del Usuario página 10

OPERATING INSTRUCTIONS
LED WORK LIGHT (Fig. 8)
The LED work light (D), located above the trigger
switch ( A ), will illuminate when the trigger switch is
depressed. This provides additional light on the surface
of the workpiece for operation in lower-light areas. The
LED work light will turn off when the trigger switch is
released.
INSTALLING THE BELT CLIP (Fig. 9)
1. Align the rib of the belt clip (J) with the hole on the
base of the drill.
2. Insert the screw and tighten the screw securely with a
screwdriver.
REMOVING THE BELT CLIP (Fig. 9)
1. Use a screwdriver to loosen the screw that attaches
the belt clip (J) to the drill.
2. Remove the screw and the belt clip.
INSTALLING THE BIT HOLDER (Fig. 10)
The bit holder (K) at the base of the tool can store 2 bits.
1. Align the rib of bit holder with the hole on the base
of the drill.
2. Insert the screw and tighten the screw securely with a
screwdriver.
REMOVING THE BIT HOLDER (Fig. 10)
1. Use a screwdriver to loosen the screw that attaches
the bit holder (K) to the drill.
2. Remove the screw and the bit holder.
8
D
A
9
10
10
J
J
K
K