Electric Brake - Kobalt KT200A Manual Del Usuario

OPERATING INSTRUCTIONS
Use 1 for starting holes without a center punch, drilling metals, plastics or ceramics, or in
applications that require a higher torque.
2 is better for drilling wood and wood composites and for using abrasive and polishing accessories.
NOTE: Never change gears while the tool is running. Failure to obey this caution could result in
serious damage to the drill/driver.
NOTE: Avoid running the drill/driver at 1 speed for extended periods of time. Running at 1 speed
under constant use may cause the drill/driver to become overheated. If this occurs, cool the drill/
driver by running it without a load at 2 speed.
DIRECTION-OF-ROTATION SELECTOR
(FORWARD/CENTER LOCK/REVERSE) (Fig. 4)
The direction of bit rotation is reversible and is controlled
by a selector located above the trigger switch (A). With
the drill/driver held in the normal operating position,
pointing away from you:
1. Position the direction-of-rotation selector (B) to the left
of the tool for forward rotation.
2. Position the direction-of-rotation selector to the right of
the tool for reverse rotation.
3. Setting the switch in the OFF (center lock) position
helps reduce the possibility of accidental starting when
not in use.
NOTE: To prevent gear damage, always allow the drill/
driver to come to a complete stop before changing the
direction of rotation.
NOTE: The drill/driver will not run unless the direction-of-
rotation selector is engaged fully to the left or right

ELECTRIC BRAKE

To stop the drill/driver, release the trigger switch and
allow the tool to come to a complete stop. The electric
brake quickly stops the rotation. This feature engages
automatically when you release the trigger switch.
NOTE: This drill/driver is equipped with an electric brake.
When the brake is functioning properly, sparks may be
visible through the vent slots in the housing. This is
normal and is the action of the brake.
4
8
B
A