Publicidad
Step 7
Step
Carefully turn your unit over onto its front edges. Unfold the
å
BACK (E) and lay it over your unit.
Make equal margins along all four edges of the BACK (E).
å
Push on opposite corners of your unit if needed to make
it "square".
Fasten the BACK (E) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over
å
the SHELF (F).
NOTE: Perforations have been provided for access through
å
the BACK. Carefully cut out the hole if needed.
Fasten the BALLASTS (VV and WW) to the BOTTOM (D2).
å
Use two BLACK 3" PAN HEAD SCREWS (84S).
WW
WW
BLACK 3" PAN HEAD SCREW
(2 used in this step)
Page 12
These holes must line up over the SHELF (F).
D2
VV
VV
84S
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
(52 used in this step)
E
411802
1N
NAIL
www.sauder.com/services
Publicidad
