LUCCI Air AIRFUSION BALI Instrucciones De Instalación página 14

AIRFUSION BALI Installation Instructions
PAIRING REMOTE AND RECEIVER – WHEN 2 OR MORE DC CEILING FANS ARE INSTALLED IN ONE
LOCATION
When two or more ceiling fans are located near each other, you may desire to have the remote/receiver for
each fan paired so that the operation of one fan does not affect the operation of the other fans.
NOTE: Ensure that you have installed a single pole disconnection switch in the fixed wiring for each fan.
NOTE: Ensure power to the Receiver is ON prior to pairing the remote with the receiver.
Remote / Receiver pairing for ceiling fan 1:
•
Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
•
Install the batteries into the remote. Please make sure the polarity of the battery is correct.
•
Turn ON the power to receiver 1. Keep the power OFF to receiver 2. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the remote will be ON).
•
Press and hold the "
to the receiver of ceiling fan 1.
•
There will be a notification 'beep' sound from the receiver to indicate that the paring process is successful.
•
Turn ON the fan and change the speed of the ceiling fan 1 by the remote to check the operation and
successful paring.
•
If pairing has been unsuccessful, repeat these set of steps again
Remote / Receiver paring for Ceiling fan 2:
•
Turn OFF the mains supply to the receivers of both ceiling fans 1 and 2.
•
Install the batteries into the remote. Please make sure the polarity of the battery is correct.
•
Turn ON the power to receiver 2. Keep the power OFF to receiver 1. (Each ceiling fan must have its own
isolation switch, so that only the ceiling fan that needs to be paired with the transmitter will be ON).
•
Press and hold the "
to the receiver of ceiling fan 2.
•
There will be a notification 'beep' sound from the receiver to indicate that the paring process is successful.
•
Turn ON the fan and change the speed of ceiling fan 2 by the remote to check the operation and
successful pairing.
•
If pairing has been unsuccessful, repeat these set of steps again
13 | P a g e
" button of remote 1 for 3-5 seconds within 30 seconds of switching the power ON
" button of remote 2 for 3-5 seconds within 30 seconds of switching the power ON