Adjusting The Cutting Blades - Maruyama BH24G Manual Del Propietário

NOTE:
1. Never mix gasoline and oil directly in the Hedge Trimmer fuel tank.
CAUTION!
1. Do not use National Marine Manufacturerʼs Association (NMMA) or BIA certified oils. This type
or two-stroke engine oil does not have the proper additives for air-cooled, two-stroke engines
and can cause engine damages.
2. Do not use automotive motor oil. This type of oil does not have the proper additives for air-
cooled, two-stroke engines and can cause engine damage.

ADJUSTING THE CUTTING BLADES

CAUTION-DO NOT TOUCH THE SHARPENED EDGES OF THE CUTTING
BLADES. THE CUTTING BLADES ARE EXTREMELY SHARP AND
DANGEROUS AT ALL TIMES. ALWAYS WEAR GLOVES TO HELP PROTECT
YOUR HANDS AND FINGERS FROM INJURY.
Before operating the Hedge Trimmer check the adjustment of the cutting blades. Blades that
are too loose may vibrate and will not provide a clean smooth cut.
CAUTION-BLADES THAT ARE TOO TIGHT CAN CAUSE OVERLOADING
WHICH MAY DAMAGE THE EQUIPMENT.
To adjust the cutting blades, refer to the illustrations and locate the screws.
Loosen the nuts.
Gently turn the screws in until snug, then turn the
screws back out one-fourth to a half. While hold-
ing the screws in place, tighten the nuts. Liberally
coat the cutting blades with light oil. Start the
engine and operate the Hedge Trimmer at full
speed for at least one minute. Stop the engine,
when the blades are motionless, touch the blades
with your hand.
The blades should be warm, if they are too hot to
touch, loosen the screws 1/8 turn.
English
upper blade
lower blade
｜ 15 ｜
nut
guide bar
washer
screw
nuts
screws