Fossil JS25 Manual Del Usuario página 10

4. Pull crown out to position 3 when the second hand is at the
12:00 position.
5. Turn crown to set time.
NOTE: 24-hour hand moves correspondingly with the
hour and minute hands. When setting the time be sure to
check that the 24-hour hand is set properly.
6. Return crown to position 1.
NOTE: When the crown is in position 2, do not press the
pushers. Otherwise the chronograph hands will move.
Chronograph Functions
Basic Function
1. Press A to start/stop the chronograph.
2. Press B to reset to zero.
Interval Timing
1. Press B while the chronograph is running.
2. Press B again to return to the chronograph.
3. Press A to finalize timing.
4. Press B to reset.
Chronograph Zero Reset
1. If either of the chronograph hands is not at the zero
(12:00) position, pull crown out to position 3.
2. Press A to move hands clockwise; press B to move hands
counter-clockwise.
3. Return crown to position 1.
18
AUTOMATIC 82SO
1. Pull crown out to position 2.
2. Turn crown clockwise to advance hour and minute
hands.
3. Push crown back to position 1.
NOTE: A timepiece with an automatic winding movement
obtains the power to wind itself by the movement of
your wrist, there is no battery. Therefore, not wearing the
timepiece for several consecutive days could exhaust the
power reserve. If your watch stops, it is recommended that
you manually wind the movement by rotating the crown
clockwise at position 1 to achieve the necessary power
reserve.
It is important your timepiece is adjusted to match the size
of your wrist. A loose fit may result in a loss in capacity
of the timepiece to wind itself. When fully wound, your
timepiece has a power reserve of approximately 36 hours.
1 2
19