Important; Maintenance Of Synthetic Wood Parts; Clearray™ Maintenance - Jacuzzi lodge MLS Uso-Mantenimiento

The emptying of the hot tub is not complete; stagnant water on
the seats and bottom of the tub can be eliminated with a sponge,
while water left in the hoses can be sucked out through the hydro-
massage and suction intakes, using a liquid-suction pump. It is ad-
visable to empty the pump as well via the appropriate drain plug.

IMPORTANT

In cold climates, where temperatures drop well below 0°C,
all residual water should be eliminated from the circuit.
Remove and clean the filter cartridge and store in a dry place.
Cover the hot tub to keep it clean.
Before you use the hot tub again, refer to the chapter on op-
erating checks for first start-up.
In areas where temperatures only occasionally drop below 0 °C,
the hot tub can be left in operation, since it is equipped with an
anti-freeze protection that ensures that a minimum water tempera-
ture is maintained (see the chapter "Setting water temperature", which
contains paragraphs on maintaining the minimum water temperature
and preventing freezing of water in the pipes - "Smart Winter" mode).

Maintenance of synthetic wood parts

Synthetic wood panels require little maintenance; use a neutral
detergent when cleaning, rinsing with clean water.
CAUTION
Do not use jets of water to clean panels as they may pen-
etrate into the hot tub technical compartment and cause
damage to the electrical system.
Clearray™ Maintenance
The Clearray™ filtering system uses a UV lamp. The lamp must be
replaced after one year.
CAUTION
Do not carry out any UV lamp cleaning or replacement
operations. Staring at the UV lamp when on may cause
serious harm to sight or even blindness. Contact the
dealer or an authorised assistance centre.
23