Operating Instructions; Water Level; Important; Whirlpool Control Panel - Jacuzzi ALLUSION 6636 Manual De Instalación Y Operación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation
Note: These instructions pertain to all bath products manufactured by Jacuzzi Whirlpool Bath. Not all features
discussed in this instruction pamphlet apply to all baths.
All baths manufactured by Jacuzzi Whirlpool Bath are designed for "fill and drain," which means the bath should be drained
after each use and filled with fresh water by the next bather. This is a health precaution, as these baths are not designed to hold
water continuously like pools or spas. If you want a unit designed to continuously hold water, see your Jacuzzi Whirlpool Bath
dealer for the complete line of whirlpool spas available.
Once the bath is installed, remove any residue or foreign materials left over from construction. Paint, tar, or other difficult
surface stains can be removed with paint thinner, turpentine, or isopropyl alcohol (rubbing alcohol). NOTE: Use these chemi-
cals only on SURFACE stains. Other dirt can be cleaned off with a mild liquid detergent on a damp cloth. Scrape off plaster with
a wooden or plastic edge; do not use metal scrapers, wire brushes or other metal tools, as they will damage the bath's
surface.

Water Level

Close the drain and fill the bath until water is at least 1" above the highest jet (see water line indicated in the illustration). Do
not turn on the whirlpool system at any time if the jets are not completely immersed in water. Running the whirlpool
system when there is insufficient water in the bath could result in water spraying outside the bath area. Running the whirlpool
system without water will damage the recirculating pump.
IMPORTANT: When exiting the bath, the water level will drop below the jets which could result in water being sprayed out of the
unit. To prevent this, you must turn unit off before exiting bath.
Jacuzzi Whirlpool Bath© BR28000A 3/05

OPERATING INSTRUCTIONS

FILL TO AT LEAST
1" ABOVE HIGHEST JET
TYPICAL BATH FITTINGS
FULLY
FULLY
ADJUSTABLE
ADJUSTABLE
SIDE JETS
BACK JETS
AIR JETS
SUCTION COVER
8

WHIRLPOOL CONTROL PANEL

WATER LEVEL SENSOR
AIR BATH
LIGHT
CONTROL PANEL
DRAIN/OVERFLOW

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Allusion 7236Allusion 7242

Tabla de contenido