JANE SOLO Manual Del Usuario página 14

1-INSTRUCTIONS
Read these instructions carefully before use and keep them for future reference.
Your child's safety may be affected if you do not follow these instructions.
This vehicle is intended for children from 6 months and up to 15 kg.
Suitable for children under 6 months old only with accessories approved by JANÉ.
WARNING: It may be dangerous to leave your child unattended.
WARNING: Make sure that all the locking mechanisms are engaged before use.
Accessories which are not approved by JANÉ shall not be used.
WARNING: Any load attached to the handle affects the stability of the vehicle.
2-TO UNFOLD THE PRAM
-Press the button on the right-hand grip (fig. 1).
-Press the rear pedal and pull on the grips (fig. 2).
3- SYSTEM
The chassis of your pushchair incorporates the PRO FIX system and is compatible with Capazo Pro, and Rebel Pro and Matrix Pro baby carriers. The PRO FIX system
enables you to fit these accessories securely to the chassis, and detach them, in a quick and easy manner. For fitting and detaching them, follow the instructions for
these accessories carefully. Your SOLO chassis is compatible with the Matrix Pro and Rebel Pro baby carriers and the SOLO carrycot (fig. 3).
4-STEERING
This model can be steering: A -Swivelling and B -Fixed (fig. 4).
5-BRAKES
There is a brake on the four rear wheels. To engage it press down on the foot lever (fig. 5).
6-SAFETY BELT
WARNING: Always attach the safety belt to the child when using the SOLO (fig. 6).
The two side fastening points of the seat can be used to fasten a supplementary harness (Fig. 6).
-Your SOLO is fitted with a 5-point harness.
-Position the child in the seat and pass the strap (1) between his legs.
-Pass the strap (2) over the child's shoulders and then insert the hooks (3)
into the buckle (4). The harness will click when it is securely fastened.
7-USING AS A STROLLER
-Adjustable grip: press button A to adjust the position (fig. 7).
-Five backrest positions (fig. 8).
-Two leg-rest positions (fig. 9).
-To remove upholstery, remove fasteners and pull upwards. To replace, fit over the upper section (see diagram). Insert the "between legs" strap through the upholstery
eyelet A insert the footrest lever B. Secure the six upholstery fasteners (fig. 10).
-To remove protector, press the button at the bottom of the armrest (fig. 11).
-Rear suspension adjustment system (fig. 12).
-To remove the backrest, press the trigger releases located below the upholstery support A, then remove the adjustment pins shown in figure B (fig. 13).
8-TO FOLD THE PRAM
-Pull buttons on grips (fig. 14-15). -Push the handlebar down until the seat engages (fig. 16).
-Adjust the length of the strap on the shoulders and the waist
according to the size of the child.
-Always use the seatbelt.
14