CUTLERY DRYER/POLISHER
RECOMMENDATIONS FOR USE
1. Lift the container guard (B).
2. Insert the "corncob" powder in the tank.
3. Press the button (A5) to activate the operation of the UV lamp (C).
4. Close the container guard (B).
5. Press the main switch (A1) to turn on the appliance.
6. Wait about 15÷20 minutes for the appliance to reach the correct operating temperature.
7. Remove the support (D).
8. Put a tray above the support (D).
9. Press the button (A3) to start the appliance.
10.Insert the cutlery , in a horizontal position, in the insertion nozzle (E).
Caution - Precaution
During operation do not put your hands in the exit nozzle (F).
11.Press the button (A4) to stop the appliance when finished.
Before activating the appliance for the first time, make sure that the protective coat-
ing film has been removed completely.
EN
To ensure hygiene the first time the appliance is used, clean it thoroughly with suit-
able products in order to remove any residue.
Important
DO NOT use corrosive or flammable cleaning products or products containing sub-
stances toxic to personal health.
APPLIANCE CLEANING
Before cleaning the appliance (at the end of the day or when necessary) turn the power off
(or unplug the power cord).
1. Accurately clean the work surface and all surrounding areas.
2. Clean external appliance surfaces with a damp cloth or sponge.
Caution - Precaution
Only use suitable detergents for cleaning.
DO NOT use corrosive or flammable cleaning products or products containing sub-
stances toxic to personal health.
Before a long period of disuse of the appliance
Before a long period of disuse of the appliance, it is good practice to disconnect it from the
power supply (or disconnect the plug) and clean it.
Protect the appliance suitably to prevent dust deposits from building up.
Before putting the appliance back into service after a long period of inactivity, carry out a
thorough inspection and clean it.
ALP/3000 - ALP/6000
- 8 -
English language