Weight Only Operation; Set Up Your Profile - Gima 27088 Manual De Instrucciones

21

Weight Only Operation

The Body Fat Analyzer will operate as a conventional weight - reading scale. No special programming
steps are required.
Once the scale is initialized, as previously described, you may simply step on the scale to measure your
current weight. For only weight reading.
1. Position the scale on a flat, hard surface.
Carpeted or uneven floors may affect accu-
racy.
2. Step onto the scale platform and remain still
while the scale computes your weight.
3. The scale will display your weight value.
4. The scale will turn off after a few seconds

Set Up Your Profile

The body fat analyzer GBF-835 supports multiple users (Up to Eight). You may follow below instructions
to assign User ID and set up your own profile, including Gender, Stature, and Age.
1. Assigning User ID
• With batteries correctly installed, press "SET" key to enter setting when the scale
is off.
• The system will request User ID selection first. As pictured below, "P1" blinks.
The operator may press the function key  or  to select User ID among P1 to
P8.
• Press "SET" key to confirm User ID.
2. Setting Gender
• After confirming User ID, the system will divert to Gender setting.
• As pictured below, the portrait
Gender( Male/Female/Male Athlete/ Female Athlete).
• Press "SET" key to confirm Gender.
Athlete Mode:
An athlete is considered as a person who does 10 hours or more per week of aer-
obic activity and has a resting heart rate of 60 beats per minute. These individuals
should select Athlete Mode for the most accurate measurement results. The body
fat analyzer are not calibrated for professional athletes or body builders.
3. Setting Stature
• After confirming Gender, the system will divert to Stature setting automatically.
• As pictured below, the digits " 165 "blinks. The operator may press the function
key  or  to increase or decrease the numeral.
• You may press and hold the function key  or  for fast changing the numer-
al.
• Press "SET" key to confirm.
blinks. The operator may press the function key  or  to select
ENGLISH