Publicidad
Step 18
Turn the HUTCH DRAWER BOX over onto its top.
å
Slide the HUTCH DRAWER BOTTOM (EE) underneath the
å
METAL BRACKETS (WW).
Make equal margins along two short edges of the HUTCH
å
DRAWER BOTTOM (EE). Be sure the HUTCH DRAWER BOTTOM
is against the METAL BRACKETS. Push on opposite corners of
your box if needed to make it "square".
With a hammer, fasten the HUTCH DRAWER BOTTOM (EE) to
å
the HUTCH DRAWER SIDES (Y) and HUTCH DRAWER BACK (Z)
by tapping in the TACK GLIDES (YY) through the holes shown.
Finish fastening the HUTCH DRAWER BOTTOM (EE) to the
å
HUTCH DRAWER SIDES (Y) and HUTCH DRAWER BACK (Z)
using the NAILS (RRR).
(6 used in this step)
YY
Y
Z
www.sauder.com/services
RRR
NAIL
EE
Y
Notches
YY
409043
WW
EE
Page 23
Publicidad
