Publicidad
Step 3
Separate the EXTENSION SLIDES (PP) from the EXTENSION
å
RAILS (OO) as shown in the upper diagram below. Be prepared, the
parts are greasy.
Fasten the EXTENSION RAILS (OO) to the RIGHT END (A) and
å
UPRIGHT (E). Use four GOLD 5/16" FLAT HEAD SCREWS (QQQ).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of the
EXTENSION RAIL out to fi nd the other hole that lines up with the
hole in the ENDS and UPRIGHTS. Turn a SCREW into this hole.
Fasten the CABINET RIGHT (40CA) and CABINET LEFT (40CB) to
å
the RIGHT END (A) and UPRIGHT (E). Use four GOLD 5/16" FLAT
HEAD SCREWS (QQQ) through holes #1 and #3.
2
1
Roller end
Open end
Page 8
PP
Push the black lever in and pull the SLIDE from the RAIL.
3
4
4
3
E
OO
Roller end
1
Open end
2
A
OO
Hole
409043
OO
QQQ
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
www.sauder.com/services
Publicidad
