Typical Installations - Broan QTRE080C2S Manual De Instrucciones

TYPICAL INSTALLATIONS

Housing mounted to I-joists.
Housing mounted to joists.
Housing mounted
anywhere between trusses
using hanger bars.
PLAN THE INSTALLATION
COOKING AREA
Do not install above or
inside this area.
45º
NOT FOR USE IN
A COOKING AREA.
Housing mounted
anywhere between I-joists
using hanger bars.
Housing mounted
anywhere between joists
using hanger bars.
Housing mounted
anywhere between trusses
using hanger bars.
45º
Cooking
Equipment
Floor
PLAN THE INSTALLATION
INSULATION
(Can be placed
around and over
fan housing.)
FAN
HOUSING
4-IN.
ROUND
*
DUCT
*
Purchase 4-IN. ROUND
separately ELBOW(S)
The unit will operate most quietly and efficiently when located where the
shortest possible duct run and minimum number of elbows will be needed.
Use a roof cap or wall cap that has a built-in damper to reduce backdrafts.
Plan to supply the unit with proper line voltage and appropriate power
cable.
INSTALL HOUSING & DUCT
1a. Mount housing to
joist or I-joist.
Use pliers to bend
housing TABS out to
90°. Hold housing in
place so that the housing
tabs contact the bottom
of the joist. The housing
mounts with four screws
or nails. Screw or nail
housing to joist through
lowest holes in each
mounting flange, then
through highest holes.
NOTE: Mounting to
I-JOIST (shown)
requires use of
SPACERS (included)
between the highest
hole of each mounting
flange and the I-joist.
1b. Mount housing anywhere between trusses, joists,
or I-joists using hanger bars.
Sliding hanger bars are provided to allow for accurate
positioning of housing anywhere between framing. They can be used
on all types of framing (I-joist, standard joist, and truss construction)
and span up to 24" .
MODEL QTRE080C2S
( '
CONT
ROOF
CAP *
WALL
*
CAP
TABS
BD0001
SPACER
(use for mounting to I -Joist)
OR
Page 2
)
D
*
I-JOIST