Introduction; Purpose Of This Operating Guide; Additional Resources; Supplementary Documentation - Danfoss VLT Compressor Drive CDS 803 Guia De Funcionamiento

VLT® Compressor Drive CDS 803
Operating Guide

1 Introduction

1.1 Purpose of this Operating Guide

This Operating Guide provides information for safe installation and commissioning of the AC drive. It is intended for use by qualified
personnel.
Read and follow the instructions to use the drive safely and professionally.
Pay particular attention to the safety instructions and general warnings. Always keep this Operating Guide with the drive.
VLT is a registered trademark for Danfoss A/S.
®

1.2 Additional Resources

1.2.1 Supplementary Documentation

Other resources are available to understand advanced drive functions and programming.
• The Programming Guide provides information on how to program and includes complete parameter descriptions.
• The Design Guide provides detailed information about capabilities and functionality to design motor control systems.
•
The Modbus RTU Operating Instructions explains how to physically establish and configure communication between the Danfoss
FC Series and a controller using the Modbus RTU protocol. Download the Operating Instructions from
section Service and Support/Documentation.
See www.danfoss.com for supplementary documentation.
1.2.2 VLT® Motion Control Tool MCT 10 Software Support
Download the software from the Service and Support download page on www.danfoss.com.
During the installation process of the software, enter CD-key 34544400 to activate the CDS 803 functionality. An activation key is not
required for using the CDS 803 functionality.
The latest software does not always contain the latest updates for the drive. Contact the local sales office for the latest drive updates
(in the form of *.upd files), or download the drive updates from the Service and Support download page on www.danfoss.com.

1.3 Manual and Software Version

This manual is regularly reviewed and updated. All suggestions for improvement are welcome.
Table 1: Manual and Software Version
Edition
AQ321748767627, version 0301

1.4 Approvals and Certifications

Description
EU/EC Declaration of Conformity (EC/CE - European Conformity/Conformité Européenne)
Low Voltage Directive/Electromagnetic compatibility (EMC)/Restriction of Hazardous Substances
(RoHS)
Countries of use: Europe
ACMA Declaration of Conformity (RCM - Regulatory Compliance Mark)
Australian Communications Media Authority (ACMA)
Low Voltage Directive/Electromagnetic compatibility (EMC)
Countries of use: Australia and New Zealand
8 | Danfoss A/S © 2021.06
Remarks
Various editorial updates.
www.danfoss.com
Software version
6.0–10 kW (8–15 hp): Version 2.0
18–30 kW (25–40 hp): Version 61.20
Conformity mark
AQ32174876762701-000301 / 130R0627
Introduction
in the