Programming Via The Quick Menu; Programming Via The Main Menu - Danfoss VLT Compressor Drive CDS 803 Guia De Funcionamiento

VLT® Compressor Drive CDS 803
Operating Guide
3 Setup number shows the active setup and the edit setup. If the same setup acts as both active and edit setup, only that setup
number is shown (factory setting). When active and edit setup differ, both numbers are shown in the display (setup 12). The
number flashing indicates the edit setup.
4 Motor direction is shown to the bottom left of the display – indicated by a small arrow pointing either clockwise or counter-
clockwise.
5 The triangle indicates if the LCP is in Status, Quick Menu, or Main Menu.
B. Menu key
Press [Menu] to select among Status, Quick Menu, or Main Menu.
C. Navigation keys and indicator lights
Table 8: Legend to Section C
6 Com. (yellow indicator): Flashes during bus communication.
7 On (green indicator): Control section is working correctly.
8 Warn. (yellow indicator): Indicates a warning.
9 Alarm (red indicator): Indicates an alarm.
10 [Back]: For moving to the previous step or layer in the navigation structure.
11 [▵] [▿] [▹]: For navigating among parameter groups and parameters, and within parameters. They can also be used for set-
ting local reference.
12 [OK]: For selecting a parameter and for accepting changes to parameter settings.
D. Operation keys and indicator lights
Table 9: Legend to Section D
13 [Hand On]: Starts the motor and enables control of the drive via the LCP.
[2] Coast inverse is the default option for parameter 5-12 Terminal 27 Digital Input. If there is no 24 V supply to terminal 27,
[Hand On] does not start the compressor. Connect terminal 12 to terminal 27.
14 [Off/Reset]: Stops the compressor (Off). If in alarm mode, the alarm is reset.
15 [Auto On]: The drive is controlled either via control terminals or serial communication.

4.2.1 Programming via the Quick Menu

Procedure
1.
To enter the Quick Menu, press [Menu] until indicator in display is placed above Quick Menu.
2.
Press [▵] [▿] to select quick guide, closed-loop setup, compressor setup, or changes made, then press [OK].
3. Press [▵] [▿] to browse through the parameters in the Quick Menu.
4.
Press [OK] to select a parameter.
5.
Press [▵] [▿] to change the value of a parameter setting.
6. Press [OK] to accept the change.
7. Press either [Back] twice to enter Status, or press [Menu] once to enter Main Menu.

4.2.2 Programming via the Main Menu

Procedure
1.
Press [Menu] until indicator in display is placed above Main Menu.
2.
Press [▵] [▿] to browse through the parameter groups.
Danfoss A/S © 2021.06
N O T I C E
Commissioning
AQ32174876762701-000301 / 130R0627 | 27