Publicidad
SAFETY INSTRUCTIONS
use in the presence of explosive liquids or vapor.
17. Do not pick up toxic material (chlorine bleach, ammonia, drain cleaner, etc.)
18. Do not in an enclosed space filled with vapors given off by oil based paints, paint
thinner, moth proofing, flammable dust, or other explosive or toxic vapors.
19. Always unplug this appliance before connecting or disconnecting vacuum hose. Do
not allow plug to whip when rewinding.
20. Use only on dry, indoor surfaces.
21. Do not use for any purpose other than described in this user's guide.
22. Store your appliance indoor in a cool, dry area.
23. Keep your work area well dry.
24. Do not immerse the hand vacuum into water or other liquids.
25. Keep end of hose, wands and other openings away from your face and body.
26. Do not use the cleaner to clean your pets or any animal.
27. Keep the head (eyes, ear, mouth, etc.) away from the openings, when the cleaner is
working or plugging.
WARNING:
Important:
If the suction opening of the unit, the hose or the tube is blocked, switch off the vacuum
clearer and remove the blocking substance before you start the unit again.
1. Do not operate the vacuum cleaner too close to hearter or radiators.
2. Before inserting the power plug into the wall outlet, make sure that your hands are
dry.
3. Before you start the unit, make sure to remove large or sharp objects that might
damage the dust tank and hose.
4. When pulling out the power plug from the wall outlet, pull the plug not the power cord.
5. Do not use without all filters in place.
6. When using, if you learn of squeak from the cleaner, it must be suction appears to be
reduced, so you must stop (make sure the cleaner is not plugging), then clean the all air
filter.
Note: If the supply cord is damaged, it must be replaced by manufacture, service agent
or similarly qualified person in order to avoid a hazard.
WARNING:
Hold the plug when rewinding the cord. Do not allow the cord to whip when rewinding.
Use and function
Assembling vacuum cleaner
Note: Always remove the power plug from the wall outlet
before assembling or removing accessories.
1. Attaching the Flexible Hose into the vacuum connect the
flexible hose into the air intake duct, push in until you hear
a "click", indicating it is in its locked position.
2. Fitting the tube to the curved wand/hose extension. Push
the tube into the curved wand/hose extension.
3. Fitting the Floor Brush to the tube. Push the tube into the floor brush. Adjust the tube
to the desired length.
- 9 -
Publicidad
