Harbor Breeze GRACE BAY BDB52LW5LS Manual De Instrucciones página 14

FINAL INSTALLATION
4. Remove three preassembled light kit fitter screws
(P) from light kit fitter (Q).
Locate BLUE (or BLACK) and WHITE wires in
switch housing preassembled on motor housing
(D) labeled FOR LIGHT KIT CONNECTION and
remove plastic that holds these two wires together.
5.
Connect WHITE wire from switch housing to
WHITE wire from light kit fitter (Q). Connect BLUE
(or BLACK) wire from switch housing to BLACK
wire from light kit fitter (Q). Make sure molex
connections are secure.
Align holes in light kit fitter (Q) with holes in switch
housing. Note: Make sure to align gap on top edge
of the light kit fitter (Q) with the reverse switch on
switch housing for the correct fit.
6. Re-insert the light kit fitter screws (P) previously
removed (Step 4, this page) and use a Phillips
screwdriver (not included) to secure all light kit
fitter screws (P).
4
P
Q
Switch
Housing
5
Switch
Housing
Q
6
Switch
Housing
Q
14
P
BLUE (or BLACK)
WHITE
Reverse
Switch
Molex
Connections
Gap
P
D