GM 22935642 Instrucciones De Montaje

Corvette Splash Guard—Rear
Please read instructions thoroughly before starting.
Installation Time
Approximately 30 minutes.
Tools Required
Socket wrench
7 mm Socket
Plastic Trim Removal Tool
Clean Cloth/Rag
Package Contents
Description
Left Hand Splash Guard
Right Hand Splash Guard
Instruction Sheet
Installation Procedure
1. Clean and degrease body panel where splash guards are
to be located.
2. Use 7 mm Socket to remove inboard screw in location (A).
Retain fastener. See Fig. 1.
3. Use plastic trim removal tool to dislodge clips from rear
fascia and remove existing plastic trim.
4. Align splash guard clips with clip insertion holes and snap
splash guard in place. See Fig. 2.
5. Reinstall fastener in location (A).
6. Repeat procedure for the other side.
7. Guards can be cleaned with any commercially available
cleaner.
Corvette Splash Guard—Rear
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Quantity
1
1
1
AUTH
REVISION
FIGURE 1
EXISTING
PLASTIC
TRIM
FIGURE 2
SPLASH
GUARD
PART NO.
REV 26AU13
INSTALLATION INSTRUCTIONS
DR
TITLE
Corvette Splash Guard—Rear
PART NO.
22935642
7 MM SCREW
7 MM SCREW
22935642
SHEET
1
SHEET
1 3
OF
3
OF