GM 22893929 Instrucciones De Montaje

Front Side Door Molding Replacement
Callout
Caution: Refer to Exterior Trim Emblem Removal
Caution.
Procedure
1. Use masking tape to mark the position of the front
side door molding prior to removal.
2. The part and surface should be 21°C (70°F) prior to
installation. The vehicle should remain 21°C (70°F)
for one hour after assembly to allow adhesive to
GHYHORS VXI¿FLHQW ERQG VWUHQJWK
3. Use a heat gun or equivalent to remove the front
1
VLGH GRRU PROGLQJ 8VH D SODVWLF ÀDW EODGHG WRRO WR
assist in removal.
4. Clean any remaining residue with a 50/50 mixture
by volume of isopropyl alcohol and clean drinkable
water. Wipe surface dry with a clean lint-free towel.
5. When removing protective liners from the adhesive
tape, be careful not to touch tape with hands and
do not allow tape to come in contact with dirt or any
foreign matter prior to adhesion.
6. Using the palm of the hand, wet out the front side
door molding to ensure full adhesion is made.
Body Side Mouldings—Chrome (B85/RWI)
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Body Side Mouldings—Chrome (B85/RWI)
Component Name
REVISION
Rear Side Door Molding Replacement
Callout
Caution: Refer to Exterior Trim Emblem Removal
Caution.
Procedure
1. Use masking tape to mark the position of the rear
side door molding prior to removal.
2. The part and surface should be 21°C (70°F) prior to
installation. The vehicle should remain 21°C (70°F)
for one hour after assembly to allow adhesive to
GHYHORS VXI¿FLHQW ERQG VWUHQJWK
3. Use a heat gun or equivalent to remove the rear
1
VLGH GRRU PROGLQJ 8VH D SODVWLF ÀDW EODGHG WRRO WR
assist in removal.
4. Clean any remaining residue with a 50/50 mixture
by volume of isopropyl alcohol and clean drinkable
water. Wipe surface dry with a clean lint-free towel.
5. When removing protective liners from the adhesive
tape, be careful not to touch tape with hands and
do not allow tape to come in contact with dirt or any
foreign matter prior to adhesion.
6. Using the palm of the hand, wet out the rear side
door molding to ensure full adhesion is made.
Exterior Trim Emblem Removal Caution
Caution: 8VH D SODVWLF ÀDWEODGHG WRRO WR SUHYHQW SDLQW GDPDJH
when removing an emblem/name plate.
PART NO.
REV 29MY13
INSTALLATION INSTRUCTIONS
AUTH DR
TITLE
Body Side Mouldings—Chrome (B85/RWI)
PART NO.
22893929
Component Name
22893929
SHEET
1
SHEET
1 3
OF
3
OF