GM 22922814 Procedimientos De Instalación

Chevy LWB Splash Guard—Rear
Please read instructions thoroughly before starting.
Installation Time
Approximately 30 minutes.
Tools Required
T15 Torx Screw Driver
Drill
1/8" (3.0 mm) Drill Bit
Clean Cloth/Rag
Package Contents
Description
Left-Hand Splash Guard
Right-Hand Splash Guard
M4.2 x 20 Self-Tapping Screw
U-nut
Alcohol Prep-Wipes
Instruction Sheet
Installation Procedure
1. Remove rear tire.
2. Clean and degrease body panel where splash guards are
to be located.
3. Clean area where tape will contact body parts withAlcohol
Prep-Wipe.
4. Remove three screws (A), (B) and (C). Hold the splash guard
in position against the rear fascia and install the supplied
0 [  VFUHZV 0DNH VXUH WKH VSODVK JXDUG VLWV ÀXVK WR
the vehicle. See Fig. 1
5. Remove the tape liner from the inside edge of the splash
JXDUG DQG DSSO\ ¿UP KDQG SUHVVXUH IRU DW OHDVW  VHFRQGV
See Fig. 2
6. Drill a 1/8" (3.0 mm) hole at location (D) and install the
M4.2 x 20 screw along with U-nut (used as a nut) into the
new hole location (D). The U-nut should be located behind
WKH IDVFLD QRW FOLSSHG RQWR WKH IDVFLD ÀDQJH  See Fig. 3
7. Repeat procedure for the other side.
8. Guards can be cleaned with any commercially available
cleaner.
Chevy LWB Splash Guard—Rear
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Quantity
1
1
8
2
2
1
AUTH
REVISION
FIGURE 1
FIGURE 1
SELF-TAPPING SELF-TAPPING
SCREWS
SCREWS
FIGURE 2
FIGURE 2
FIGURE 3
FIGURE 3
FIGURE 3
D
PART NO.
IR 15MY13
INSTALLATION INSTRUCTIONS
DR
TITLE
Chevy LWB Splash Guard—Rear
PART NO.
22922814
C
B
A
SPLASH
SPLASH GUARD
GUARD
TAPE LINER
VIEW FROM
VIEW FROM
U-NUT
U-NUT
BELOW
BELOW
DRILL
DRILL
HERE
HERE
SELF-TAPPING SCREW
SELF-TAPPING SCREW
22922814
SHEET
SHEET
TAPE
LINER
D
1 3
OF
1 3
OF