GM 22935638 Instrucciones De Montaje

Corvette Splash Guard—Front
Please read instructions thoroughly before starting.
Installation Time
Approximately 30 minutes.
Tools Required
Socket wrench
7 mm Socket
Plastic Trim Removal Tool
Clean Cloth/Rag
Package Contents
Description
Left Hand Splash Guard
Right Hand Splash Guard
Instruction Sheet
Installation Procedure
1. Turn front tire to provide clearance.
2. Clean and degrease body panel where splash guards are
to be located.
3. Use 7 mm socket to remove screw in location (A). Retain
fastener. See Fig. 1.
4. Use plastic trim removal tool to dislodge existing panel clips
from fender. Remove the existing plastic trim.
5. Guide splash guard tab into wheel liner slot. See Fig. 2.
6. Align splash guard clips with clip insertion holes and snap
splash guard in.
7. Reinstall fastener in location (A). See Fig. 2.
8. Repeat procedure for the other side.
9. Guards can be cleaned with any commercially available
cleaner.
Corvette Splash Guard—Front
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Quantity
1
1
1
AUTH
REVISION
FIGURE 1
EXISTING
PLASTIC
TRIM
FIGURE 2
TAB
IN
SLOT
VIEW FROM
BEHIND
PART NO.
REV 26AU13
INSTALLATION INSTRUCTIONS
DR
TITLE
Corvette Splash Guard—Front
PART NO.
22935638
7 MM SCREW
TAB
SPLASH GUARD
7 MM SCREW
22935638
SHEET
SHEET
1 3
OF
1 3
OF