Final Steps - KTM 69008915033 Guia De Inicio Rapido

3
6
3
4
1
2
A
5
B
5
- Connect the left (1) and right (2) turn signal connectors on the wiring har-
ness of the license plate lamp (3).
- Properly route the cables using the cable binders (Figures A + B)
- Route the wiring harness (3) through the opening (4) toward the front (Figure
B).
- Connect the connection cable

FINAL STEPS

- Mount the seat.
- Check the functions.
Check that the left and right turn signals indicate the direction specified by
the turn signal switch. If not, reverse the cables.
NOTE:
If needed, the plate for the reflector can be mounted as well.
(5) to the wiring harness. (5)