Package Contents; Description (Fig. A); Electrical Safety - DeWalt DW310 Manual Del Usuario

d Store idle power tools out of the reach of
children and do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users.
e Maintain power tools. Check for misalignment
or binding of moving parts, breakage of parts
and any other condition that may affect the
power tools operation. If damaged, have the
power tool repaired before use. Many accidents
are caused by poorly maintained power tools.
f Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g Use the power tool, accessories and tool bits
etc., in accordance with these instructions
and in the manner intended for the particular
type of power tool, taking into account the
working conditions and the work to be
performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5 Service
a Have your power tool serviced by a qualified
repair person using only identical replacement
parts. This will ensure that the safety of the
power tool is maintained.
Additional safety rules for cutsaws
Switching on and off
• After switching off, never attempt to stop the saw
blade with your fingers.
• Never put the saw down on a table or work bench
unless switched off. The saw blade will keep
running briefly after the tool has been switched off.
When sawing
• When using saw blades specially designed for
cutting wood remove all nails and metal objects
from the workpiece before starting work.
• Wherever possible, use clamps and vices to
fasten the workpiece securely.
• Do not attempt to saw extremely small workpieces.
• Do not bend too far forward. Make sure that you
always stand firmly, particularly on scaffolding
and ladders.
• Always hold the saw with both hands.
• For cutting curves and pockets, use an adapted
saw blade.
Checking and changing the saw blade
• Only use saw blades conforming to the
specifications contained in these operating
instructions.
• Only sharp saw blades in perfect working
condition should be used; cracked or bent saw
blades should be discarded and replaced at once.
• Ensure that the saw blade is securely fixed.

Package contents

The package contains:
1 Reciprocating saw
1 General purpose saw blade set
1 Kitbox (K-models only)
1 Instruction manual
1 Exploded drawing
• Check for damage to the tool, parts or accessories
which may have occurred during transport.
• Take the time to thoroughly read and understand
this manual prior to operation.

Description (fig. A)

Your DW310/DW311K reciprocating saw has been
designed for professional sawing of wood, metal
and tubes. The compact design permits cutting
extremely close to the edge of difficult areas.
1 Variable speed switch
2 Speed control dial (DW311K)
3 Pendulum stroke selector (DW311K)
4 Blade holder
5 Saw shoe
6 Shoe release lever
7 Blade clamp collar

Electrical safety

The electric motor has been designed for one
voltage only. Always check that the power supply
corresponds to the voltage on the rating plate.
Your D WALT tool is double insulated in
E
accordance with EN 60745; therefore no
earth wire is required.
E N G L I S H
21