Turning The Lamp Head; Care And Maintenance - Hilti SL 2-A12 Manual De Instrucciones

CAUTION
Risk of injury. If the battery is not fitted correctly it may drop out and fall.
▶ Check that the battery is securely seated in the product so that it cannot
drop out and fall, thereby presenting a hazard to other persons.
▶ Insert the battery and check that the battery is securely seated in the
device.
5.3 Removing the battery
1. Press both release buttons.
2. Pull the battery to the rear and out of the product.
5.4 Pivoting the head of the lamp
1. Pull out the retractable hook.
When you suspend the lamp using the retractable hook, check the
load-bearing capacity of the point from which the lamp is suspended.
2. Pivot the head of the lamp upwards.

5.5 Turning the lamp head

CAUTION
Risk of damage to the eyes (the retina). Looking directly into the lamp
presents a risk of damage to the eyes (the retina).
▶ Do not direct the lamp at yourself or at anyone else.
▶ Do not, under any circumstances, look into the lamp.
▶ Turn the lamp head to the desired position.
The lamp head can be turned in either direction along the axis. Do
not attempt to force the lamp head past the end stops.
5.6 Switching on
1. Turn the lamp head to the desired position. → page 15
2. Select a mode by pressing the 3-mode switch.
6

Care and maintenance

6.1 Care and maintenance
WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance
tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt.
*2171355*
Printed: 11.04.2019 | Doc-Nr: PUB / 5346571 / 000 / 02
2171355 English 15