Receiving The Memorised Stations; Rds; Overview Of The Rds Function; Displaying The Station Name - Sony CDX-4170R Manual De Instrucciones

Receiving the memorised
stations
1
Select the desired band (page 8).
2
Press the number button ((1) to (6))
momentarily where the desired station is
stored.
If you cannot tune in a preset
station
Press either side of (SEEK/AMS)
momentarily to search for the station
(automatic tuning).
Scanning stops when the unit receives a
station. Press either side of (SEEK/AMS)
repeatedly until the desired station is
received.
Note
If the automatic tuning stops too frequently, press
(SENS/BTM) momentarily until "LCL" appears in
the display (local seek mode). Only the stations
with relatively strong signals will be tuned in.
Tip
If you know the frequency of the station you want
to listen to, press and hold either side of
(SEEK/AMS) for two seconds until the desired
frequency appears (manual tuning).
If FM stereo reception is poor
— Monaural Mode
Press (SENS/BTM) momentarily until
"MONO" appears.
The sound improves, but becomes
monaural ("ST" disappears).
To go back to the normal mode, press again
until "MONO" disappears.
Changing the displayed items
Each time you press (DSPL), the items
alternate between the frequency and time.

RDS

Overview of the RDS
function
The Radio Data System (RDS) is a
broadcasting service that allows FM stations to
send additional digital information along with
the regular radio programme signal. Your car
stereo offers you a variety of services. Here are
just a few: re-tuning the same programme
automatically, listening to traffic
announcements and locating a station by
programme type.
Notes
• Depending on the country or region, not all of
the RDS functions are available.
• RDS may not work properly if the signal strength
is weak or if the station you are tuned in to is
not transmitting RDS data.
Displaying the station
name
The name of the station currently received
lights up in the display.
Select an FM station (page 8).
When you tune in an FM station that
transmits RDS data, the station name
appears in the display.
FM1
B B C 1 F M
Note
The "*" indication means that an RDS station is
being received.
Changing the displayed items
Each time you press (DSPL), the item changes
as follows:
" Frequency " Clock
Note
"NO NAME" appears if the station received does
not transmit RDS data.
EN
" Station Name
9