Installation - Mitsubishi Electric PAR-SL101A-E Serie Manual De Instrucciones / Manual De Instalación

3. Installation

■ Use the remote controller holder that is provided to avoid misplacing the remote controller.
■ Install the remote controller in a location that meets the following conditions.
• Out of the direct sun light
• Away from any heat sources
• Out of the airflow from the air conditioner (cool or warm)
• Where the operation of the remote controller can easily be performed and the display is
readily visible to the user
• Out of the reach of small children
NOTES:
* If there is a fluorescent light in the room in which the air conditioner is to be installed, turn it
on and make sure that the signal from the remote controller can be received by the indoor
unit from the intended installation location. When the signal receiving unit receives a signal
from the remote controller, a short beeping sound will be heard.
If the air conditioner unit is installed in a room in which a fluorescent light on an electronic
lighting control system (i.e., inverter light) is installed, signal interference may occur.
* Maximum signal receiving distance is approximately 7 meters (Approx. 22 feet). Signal
receiving angle is approximately 45 degrees to the right and the left from the center.
* Install the unit at least 1 meter (Approx. 3 feet) away from the TV or radio.
(If the unit is installed too close to these appliances, signal interference (picture distortion
and noise) may occur.)
■ Use the tapping screws that are provided to mount the remote controller holder on the wall,
and then place the remote controller in the holder.
1. Remove the top cover, insert two LR6 AA batteries, and then install
the top cover.
1
Top cover
2
Two LR6 AA batteries
3
Insert the negative (–) end of each
battery first. Install the batteries in
the correct directions (+, –)!
Remote
controller
Holder
2. Press the Reset button.
Press the Reset but-
ton with an object that
has a narrow end.
en
Self-tapping
screws
3