Changing The Backlight Setting; Completing The Settings; Function Settings; Switching To The Function Setting Mode - Mitsubishi Electric PAR-SL101A-E Serie Manual De Instrucciones / Manual De Instalación

5. Initial setting

6. Function settings

B
4
2
Fig. 6-1

5.6. Changing the backlight setting

(Fig. 5-1, Fig. 5-3 F)
Press the
• Pressing the
(

5.7. Completing the settings

(Fig. 5-1, Fig. 5-2)
Press the
• The function No. A blinks.
Press the
• The remote controller exits the initial setting mode.
(The air conditioner operation is stopped.)
To confi rm the functions and settings for the indoor unit
you want to set, refer to the operation manual and techni-
cal materials for the unit.
6.1. Switching to the function setting
mode (Fig. 6-1)
1. Press the
• If the weekly timer is enabled, press the
A
button 2 to disable the timer. (
2. Press the
• The remote controller enters the function set-
1
ting mode. (The group model setting number A
blinks.)
6.2. Entering the group model setting
number (Fig. 6-1)
Press the
• Enter the group model setting number for the in-
3
door unit you want to operate. (The factory setting
is "001".)
To confirm the group model setting number, refer
to the indoor unit operation manual.
• The fan speed, vertical airflow direction and
operation mode can be set by operating the group
model setting number.
When you want to change any settings other than
above, refer to the descriptions about the sepa-
rate setting modes in the following pages.
button 9.
button 9 changes the setting
/ ). (The factory setting is "ON".)
: The backlight comes on when a button is
pressed.
: The backlight does not come on when a
button is pressed.
button 5.
button 3.
button 1 to stop the air conditioner.
button 3 for 5 seconds.
button 4.
en
B disappears.)
7