Tristar KZ-1210 Manual De Instrucciones página 12

EN
A) General Safety Instructions
•
Read the operating instructions carefully before putting the appliance into operation and keep the instructions
including the warranty~ the receipt and, if possible, the box with the internal packing.
•
The appliance is designed exclusively for private use and for the envisaged purpose. This appliance is not fit
for commercial use. Do not use it outdoors (except if it is designed to be used outdoors). Keep it away from
sources of heat, direct sunlight, humidity (never dip it into any liquid) and sharp edges. Do not use the
appliance with wet hands. lf the appliance is humid or wet, unplug it immediately. Do not put it in water.
When cleaning or putting it away, switch off the appliance and always pull out the plug from the socket (pull
on the plug, not the cable) if the appliance is not being used and remove the attached accessories.
•
Never leave the appliance unsupervised when there are children in the area. To protect children from the
dangers posed by electrical appliances, make sure that the cable is hanging not too low and that children do
not have access to the appliance.
•
Check the appliance and the cable for damage on a regular basis. Do not use the appliance if it is damaged.
•
Do not try to repair the appliance on your own. Always contact an authorized technician. To avoid the
exposure to danger, always have a faulty cable be replaced only by the manufacturer, by our customer
service or by a qualified person and with a cable of the same type.
•
Use only original spare parts.
•
Pay careful attention to the following "Special Safety instructions".
B) Overview of the Components
1. Water tank opening
2. Hot plate for cups
3. 1 cup selector
4. Indicator light
5. Function knob
6. On/Off switch/ power button
7. 2 cups selector
8. Steam nozzle
C) Before Start-up
Unpack the Espresso machine carefully. Take out all the accessories and the packing material. Wash the
accessories in a sink. Plug in and press the power button (6). The machine is warming up. The green indicator
light flashes(4) . Press both one (3) and two cup buttons (7) together for 3 seconds. The heating indicator will
flash quicker, meanwhile the pump inhale water until the setting time and then the pump stop. If the coffee status
is ready the light (4) is lighten up.
If you ignore this step for the first time, after pre-heating, the indicator will be lighted permanently, the machine is
ready for use.
D) 1 cup setting volume
Place the small filter (12) in the filter holder (10) and fill this with coffee powder.
Make sure that you preheat the coffee machine.
Press the 1 cup volume button (3) for 3 seconds.
The heating indicator light (4) flashes.
If the volume is good for you then press the 1 cup button to stop. The setting is done.
After brewing, the indicator light (4) still flashes, and the machine are reheating until the setting temperature and
then the indicator light will be lighted permanently.
Please note that the maximum setting volume is 200cc and the minimum is 30cc.
E) 2 cups setting volume
Place the large filter (13) in the filter holder (10) and fill this with coffee powder.
Make sure that you preheat the coffee machine.
Press the 2 cups volume button (7) for 3 seconds.
The heating indicator light (4) flashes.
If the volume is good for you then press the 2 cups button to stop. The setting is done.
After brewing, the indicator light (4) still flashes, and the machine are reheating until the setting temperature and
then the indicator light will be lighted permanently.
Please note that the maximum setting volume is 200cc and the minimum is 30cc.
F) Go back to the default setting
Make sure that the coffee machine is ready for use.
Press 1 and 2 cup button at the same time for 3 seconds. The indicator light flashes 1 time. The indicator light is
permanently and then go back to the default setting.
9. Water level scale
10. Filter holder
11. Special lever
12. Small filter (1 cup)
13. Large filter (2 cups)
14. Drip barge
15. Drip tray
16. Coffee spoon