Radio Reception; Radio; Alarm; Setting The Alarm Time - Grundig SONOCLOCK 740 Manual De Instrucciones

RADIO

Radio reception

The radio only functions after time adjustment.
This ensures the fastest possible time signal reception,
which is then not disturbed by the radio.
• If you wish to switch on the radio before time signals have
been received, you should first set the time manually as
described before.
• Then, switch on the radio with the ON/OFF button.
– The illuminated dial pointer led (TUNING DIAL 6). serves
as 'on' indicator.
• Tune to stations with the rotary control TUNING.
• Adjust the volume with the rotary control VOLUME
Aerials
The wire aerial at the back of the set is used for VHF (FM)
reception.
• Position the wire aerial so that optimum reception is
obtained.
NOTE:

ALARM

Alarm
• Select the required alarm time function (radio alarm or
sound signal alarm) with the switch
– If both alarm times are activated, this will be indicated by
the light dots 1 6 and

Setting the alarm time

• Press the ALARM 1 or ALARM 2 button briefly.
– The display shows the present alarm time.
• Press and hold down the ALARM 1 or ALARM 2 button
and set the alarm time with the – DOWN/+ UP buttons.
Weekend Alarm Cancellation (WEC)
• If you do not wish to be woken by the alarm on the
weekend, press WEC once.
– The WEC 6 light dot lights up.
– The alarm will function normally on the other days.
– This applies to alarm time 1 and alarm time 2.
• Press the WEC button again to switch this function off.
or .
2 6.
GB
17