Description (Fig. A); Hints For Use; Cleaning And Maintenance - Princess 201003 Manual De Instrucciones

Congratulations!
You have purchased a Princess appliance.
Our aim is to provide quality products with
a tasteful design and at an affordable price.
We hope that you will enjoy this appliance for
many years.

Description (fig. A)

Your 201003 Princess juicer has been designed
for rapidly pressing citrus fruits. The appliance
is suitable for domestic use only.
1. Dust lid
2. Pressing cone
3. Pulp collector
4. Juice collector
5. Juice outlet
6. Motor housing
7. Accessory storage
Initial use
Preparation
• Clean the appliance. Refer to the section

"Cleaning and maintenance".

Assembly (fig. A & B)
Before you proceed, we need you to pay
attention to the following notes:
­ Before assembly, remove the mains plug
from the wall socket and wait for the
motor to stop running.
• Take the pressing cone (2) from the
accessory storage (7).
• Mount the juice collector (4) onto the
motor housing (6) until it clicks into place.
• Place the pulp collector (3) onto the juice
collector (4).
• Place the pressing cone (2) onto the pulp
collector (3).
Use

Hints for use

Before you proceed, we need you to pay
attention to the following notes:
­ Do not leave the appliance switched on
continuously for more than three minutes.
­ Let the appliance cool down for
approximately five minutes after every ten
pressings.
• Assemble the juicer. Refer to the section
"Assembly".
• Cut the citrus fruit in half.
• Place the cut surface of one half onto the
pressing cone:
­ For small citrus fruits (lemons, limes,
etc.), use the small pressing cone.
­ For large citrus fruits (oranges,
grapefruits, etc.), use the large pressing
cone.
• Press the citrus fruit with one hand. The
appliance automatically starts to press the
citrus fruit. The juice automatically flows
into the juice collector.
• Place a container under the juice outlet.
Push the juice outlet downward to allow
the juice to flow. Push the juice outlet
upward to make sure that the juice outlet
does not drip.
• Press the citrus fruit until hardly any more
juice is extracted from the citrus fruit.
The appliance automatically stops when
the pressure is released.
• Empty the pulp collector regularly, when
you process larger quantities of fruit.
• Stop pressing the citrus fruit in one of the
following situations:
­ no more juice is extracted from the citrus
fruit;
­ the juice collector is full;
­ the container is full.
• Use the dust lid according to the situation:
­ If you do not use the appliance within a
short period of time, place the dust lid
onto the appliance.
• After use, remove the mains plug from the
wall socket.
Cleaning and maintenance
The appliance must be cleaned after each use.
Before you proceed, we need you to pay
attention to the following notes:
7