Instruction manual
• Farm houses.
PARTS DESCRIPTION
1. Press handle
2. Fruit dome
3. Press cone
4. Pulp sieve
5. Reservoir
6. Juice spout
7. Motor Axis
BEFORE THE FIRST USE
•
Take the appliance and accessories out the box. Remove the
stickers, protective foil or plastic from the device.
•
Before using your appliance for the first time, wipe off all removable
parts with a damp cloth. Never use abrasive products.
•
Connect the power cable to the socket. (Note: Make sure the indicated
voltage on the device matches the local voltage before connecting the
device. Voltage 220V-240V 50-60Hz.)
USE
•
As soon as the half citrus fruit is pressed onto the juice cone, the
motor will be activated.
4
•
Place a suitable glass under the spout of the reservoir. The spout can
be pushed down to the juice to anticipate, and be folded up for the
anti-drip feature. Do not exert too much pressure on the juice cone. If
the sound of the motor increases significantly or the motor itself slows
down dramatically, this means too much pressure has been exerted.
•
Please do not run the juicer for longer than 15 seconds without
interruption, please take a break for 10 minutes after pressing 10
pieces of oranges.
•
The filter can be adjusted, it can be turned to only let juice or also pulp
pass through.
•
Note that this appliance is equipped with an overheat protection which
will turn of the device when the temperature gets too high. Once the
appliance is cooled down, the thermostat will automatically be reset
CLEANING AND MAINTENANCE
•
Unplug the appliance. Use a soft, slightly damp cloth to wipe appliance
surfaces. Do not allow water or any other liquid to get into the unit.
•
Components that have come into contact with food can be cleaned in
soapy water.
•
Do not use any abrasive detergent or steel wool to clean the
appliance, as it may scratch the surfaces.
•
The components are suitable for cleaning in a dishwasher.
•
The pressure section of the handle can be easily assembled for
cleaning.