Installing/Removing A Blade; Cutting Blades - Evolution S210CCS Manual Del Usuario

www.evolutionpowertools.com
PREPARATION
WARNING: Always disconnect the machine from the
power source before making any adjustments.
Note: These machines are equipped with an approved power
cord and plug for the intended country of use. Do not alter or
modify the power cord.

INSTALLING/REMOVING A BLADE

WARNING: Use only genuine Evolution blades which
are designed for use in these machines. Ensure that the
maximum speed of the blade is compatible with the machine.
Only perform this operation with the machine disconnected
from the power supply.
Note: It is recommended that the operator considers wearing
protective gloves when handling the blade during installation
or when changing the machines blade. The recommended
Evolution blades are shown in the table below.
Blade codes
M210TCT-50CS
T210TCT-68CS
S210TCT-54CS
A210TCT-60CS
Refer to the website for more information on the capabilities
and specification of Evolution blades.
• Locate the supplied Blade Change Hex Key, which is
housed in the onboard storage facility (18) (Fig.1)
• Place saw securely on a level, secure surface.
Note: All machines can, with care, be rested on the flat end of
the motor housing casing, (Fig. 2), easing access to the blade
and fixings.
• Remove the chip collector, (12), by depressing the release
button, (13) (Fig.3), exposing the blade bolt, (Fig.4).
• Engage the arbor lock button (17) and loosen the
blade bolt using the supplied hex key. The blade bolt is
equipped with a standard screw thread (turn the counter
clockwise to loosen).
• Remove and safely store the blade bolt and outer flange.
(Fig.5)
• Rotate the lower blade guard (16) then remove blade.
Note: The inner blade flange can be left in place if desired, but
it should be checked and thoroughly cleaned. If it is removed
from the machine it must be replaced back in the same
orientation as it was before removal.
Fig. 1

Cutting blades

Mild Steel
Thin Steel
Fig. 2
Stainless Steel
Aluminium
Fig. 3
Fig. 4
11
EN