Parallel Edge Guide - Evolution S210CCS Manual Del Usuario

Fig. 5
Fig. 6
Fig. 7
Fig. 8
• Thoroughly clean the blade around the bore area (both
surfaces) where the blade flanges will touch and clamp
the blade.
• Install the (new) blade. Ensure that the direction of
rotation arrows printed on the blade, match the direction
of rotation arrows found on the machines upper and
lower blade guards. (Fig.6).
• Allow the lower blade guard to return to its closed
position.
• Reinstall the outer flange and the blade bolt.
Note: The outer flange has a specially machined bore which
incorporates two opposed 'flats. ' , (Fig. 7), These 'flats' engage
with two complimentary 'flats' machined on the arbor shaft.
• Re-engage the arbor lock button and tighten the blade
bolt securely, using the Hex Key.
• Release the arbor lock button.
• Return the Hex Key to its dedicated on board storage
position.
• Check that the arbor lock button has fully released by
manually rotating the blade.
• Check the operation of the lower blade guard.
• Replace the chip collector.
Note: The inner flange is dual sided to suit 15.875mm (5/8") and
25.4mm (1") blade bore sizes.
Note: Ensure that the inner flange remains in place when
removing outer flange for the first time.

PARALLEL EDGE GUIDE

A removable Parallel Edge Guide, (10) which can be particularly
helpful for accuracy when rip cutting (Fig.8), is supplied with
this machine.
The guide arms should be inserted through the rectangular
slots positioned at either side of the base plate, (Fig.9), and slid
under the forward and back adjustment locking thumb screws,
(11).
Adjust the edge guide so that it is at the required distance from
the blade and tighten the adjusting screw. Check that the edge
guide is parallel to the saw blade.
Note: The Parallel Edge Guide can be fitted on either side of the
base plate.
WARNING: Only fit and adjust the Guide with the
machine disconnected from the power supply.
Note: The arms of the Parallel Edge Guide must pass through all
of the rectangular slots provided in the base plate.
12
www.evolutionpowertools.com