Auping AVX BOX spring Manual De Instrucciones página 16

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 98
■ Check if the input voltage indicated
on the transformer is the same as
the main voltage in the house.
■ Damaged
EN
should be replaced solely by the
4
manu facturer, its service division or
a similarly qualified person, to
prevent any risks.
■ Make sure that the cables cannot
become trapped. Check this by
adjusting the bed after it has been
installed.
■ Adjustable beds have moving parts.
Make sure that your limbs cannot
become trapped.
■ Release the controls immediately in
case anything becomes trapped in
between the moving parts. The
motors do not stop automatically
and continue to operate.
■ Only adjust the bed while you are
lying on it. Make sure that no children
are under the bed while it is being
adjusted.
■ Please do not sit on the head
support or foot end of the bed whilst
raised.
_0DV54_5939 BW.pdf - pag.14
power
supply
cables
LET OP !!! Lage resolutie!
■ The AVS box spring is not intended
for
use
by
persons
children) with reduced physical,
sensory of mental capabilities, or
lack of experience and knowledge,
unless
they
have
supervision or instruction concerning
the use of the appliance by a person
responsible for their safety.
■ Always place the remote control
back in its holder at the bedside. Do
not leave it in your bed, to avoid
falling asleep on it.
■ Disconnect the bed from the power
supply before cleaning. Pull the plug
out of the socket.
■ Remove the plug from the socket
during a thunderstorm.
■ Ensure that when you use an
extension cable, its power is higher
or equal to that mentioned on the
transformer.
Use
extension cable.
(including
been
given
an
approved
February 6, 2012

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Vlak455477488

Tabla de contenido