Auping AVX BOX spring Manual De Instrucciones página 21

Nothing works
Nothing works
Nothing works
Nothing works
Nothing works
The bed fails to respond
to the RF remote control
The bed fails to respond
to the RF remote control
The bed fails to respond
to the RF remote control
The box spring fails to
respond to the remote
control with cable
_ _ 0DV54_5939 BW.pdf - pag.19
Cause Search
No mains power supply. Check if the current is
switched on at the mains
power supply, or whether
another appliance has
caused a short circuit.
Transformer defect.
Short circuit in motor. Unplug motors one by
one until the system
functions again.
Unidentified malfunction.
Power failure. All other domestic
electrical appliances also
fail to work.
The batteries in the
remote control are
(almost) depleted.
The child lock is on. Press one of the buttons
of the remote control.
The red light blinks.
The receiver is not able Check if the system
to pick up the signal of works by operating the
the handset. The signal remote control directly
may fail to reach the next to the receiver.
receiver if the handset is Check if the receiver has
at a substantial distance. been fixed properly.
Ruptured wire in cable. Check cable at strain
relieve.
LET OP !!! Lage resolutie!
Solution
Throw earth leakage
circuit breaker if
necessary.
Replace.
Replace faulty motor.
Remove the plug from
the wall socket and wait
10 seconds before
replacing and/or remove
the batteries from the
remote control for one
minute.
The RF receiver has an
emergency lowering. See
chapter 4.6.
Replace batteries.
Press the red lock button
on the back side of the
remote control. Now the
green light blinks.
Relocate the receiver or
repeat the connecting
process.
Replace.
February 6, 2012
EN
9