Inserting/Replacing Batteries; Taking A Blood Pressure Measurement - Braun iCheck 7 Manual De Instrucciones

Inserting/replacing batteries

• Remove the battery compartment cover by sliding it
downwards. Insert the two batteries supplied with this product,
with polarity as indicated in the battery compartment. When
replacing batteries, use alkaline batteries exclusively,
type AAA/LR03, 1.5V.
• New batteries will provide approximately 300 measurements.
The basics
The On/Off button is located to the right of the display.
This is a round button with the power symbol. Simply tap on this
touch-sensitive button to turn your iCheck® 7 On and Off.
When turning On, you will see a welcome screen first. When
this message disappears the device will be ready to use.
The graphic display shows numerical values for measurements, indications for user,
guidance system and error notifications, if any.
At the conclusion of the measurement the device will show a coloured heart.
Use the colour codes shown on Page 6 find out what the colour means.

Taking a blood pressure measurement

1. Sit down, relax, keep still, especially the arm being used for the measurement, do not move
or speak. For greatest accuracy, we recommend using the left wrist for the measurement.
2. Fit the monitor on your left wrist, roughly 1 (one) cm
below the palm line (see Fig. 1 for correct placement).
DO NOT ATTACH LIKE A WRIST WATCH. The device
should be on the inner side of your wrist. Secure the
cuff with the Velcro fastener, so that it is tight but
comfortable. There should not be a space between the
cuff and the wrist.
3. Press the On/Off button
The graphic display will show the welcome screen
followed by the 'Easy Positioning System' . This is shown
as a moving dot within a white circle.
4
to start a measurement.
Fig. 1