GM 23228522 Procedimientos De Instalación

Chevy/GMC/Cadillac Splash Guard - Front
Please read instructions thoroughly before starting.
Installation Time:
Approximately 30 minutes
Tools Required
T15 Torx Screw Driver
Drill
1/8" (3.0 mm) Drill Bit
Clean Cloth/Rag
Package Contents
Description
Left-Hand Splash Guard
Right-Hand Splash Guard
M4.2 x 20 Self-tapping Screw
Alcohol Wipes
Instruction Sheet
Installation Procedure
1. Turn tire to provide access.
2. Clean and degrease body panel where splash guards are to
be located.
3. Clean area where tape will contact body parts with Alcohol
Prep-Wipe.
4. Remove three screws (A), (B) and (C). Discard the stone
protector (grey). See Fig. 1
5. Hold the splash guard in position against the fender and
UHLQVWDOO WKH VFUHZV 0DNH VXUH WKH VSODVK JXDUG VLWV ÀXVK WR
the vehicle. See Fig. 2
6. Drill a 1/8" (3.0 mm) hole at location (D). See Fig. 2
7. Install supplied M4.2 x 20 screw at location (D). See Fig. 2
NOTE: Max torque is 3.0 Nm (2.2 ft lb).
8. Remove the tape liner from the inside edge of the splash
JXDUG DQG DSSO\ ¿UP KDQG SUHVVXUH IRU DW OHDVW  VHFRQGV
See Fig. 3
9. Repeat procedure for the other side.
10. Guards can be cleaned with any commercially available
cleaner.
Splash Guard - Front
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Quantity
1
1
2
2
1
AUTH
REVISION
FIGURE 1
EXISTING
SCREW
EXISTING
SCREWS
M4.2 x 20 SCREW
MAX 3.0 Nm (2.2 ft lb)
FIGURE 3
PART NO.
IR 11AP14
INSTALLATION INSTRUCTIONS
DR
TITLE
Chevy/GMC/Cadillac Front Splash Guard
PART NO.
23228522
DISCARD
STONE
PROTECTOR
FIGURE 2
SPLASH
DRILL HERE
GUARD
23228522
SHEET
1
SHEET
TAPE LINER
1 3
OF
3
OF