GM 23232342 Instrucciones De Instalación

Door Sill Plate Package
Contents
Description
Front Door Plate
Rear Door Plate
Felt Block
Alcohol Prep Pads
Instruction Sheet
Verify all parts are present
Additional Tools Required:
• Masking tape
• Lint free cloth
• Heat gun (if needed)
• Approved adhesive remover (if removing existing sill plate
parts)
Preparation - Before Installation
1. If existing parts are installed, carefully remove them. Use
approved adhesive remover (VMP Naptha), to remove any
adhesive residue.
2. After opening the kit, check to see if any parts are missing or
damaged.
3. This product should be installed with proper installation tools.
4. Install this product while observing all warnings and
precautions stated in this instruction sheet.
5. Thoroughly wash entire surface area where parts will be
adhered to.
6. Temperature of sill plates and vehicle must be a minimum of
70 degrees F (21ºC) to a maximum of 90 F (32ºC).
Installation Instructions
1. Wipe area where sill plate is to be applied using supplied
alcohol prep pad and follow with a dry wipe to remove any
residual alcohol (Figure 1).
2. Prior to removing backing liner, position parts in proper
location (Figure 2) and use masking tape to mark location.
3. Lay the sill plate face down on a
remove the backing paper liner from the plate (Figure 4).
4. Carefully lift the sill plate along the edges (do not touch
the exposed adhesive) and align the parts to the masking
tape locations. Do not apply pressure until the positioning
is satisfactory. MAKE SURE LEADING EDGE OF PART
REMAINS ON FLAT AREA OF SURFACE (see Figure 3).
Note: Repositioning is not recommended but can occur if
the plate has not been pressed into place.
5. Important: Use the supplied felt block (hand pressure may not
provide the necessary "wet out") and apply
the plate starting from center and moving outboard. Use
overlapping strokes and apply pressure around the perimeter
of the plate multiple times (Figure 5).
6. For optimum performance, use a heat gun to apply heat
(120 F (48ºC) for 3 seconds) across the surface of the plate
and then re-press into place with felt block.
Door Sill Plate Package (Colorado/Canyon)
TITLE
ALL INFORMATION WITHIN ABOVE
DATE
BORDER TO BE PRINTED EXACTLY AS
SHOWN ON 8.5 x 11 WHITE 16 POUND
27MR15
NON-BOND RECYCLABLE PAPER. PRINT
ON BOTH SIDES, EXCLUDING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE WITH
GMCCA SPECIFICATIONS.
Quantity
2
2
1
4
1
surface and carefully
pressure onto
IR 27MR15
AUTH
REVISION
Initial Release - Deanna Gordon 2104106
FIGURE 1
FIGURE 2 - Front Plate
Masking Tape
Rear Plate
Masking Tape
FIGURE 3
NO
FIGURE 4
FIGURE 5
Apply pressure to entire surface with felt block
23232342
PART NO.
Installation Instructions
TITLE
DR
Door Sill Plate Package (Colorado/Can
23232342
PART NO.
YES
1 3
SHEET OF
yon)
1 3
SHEET OF