GM 23257027 Manual De Instrucciones

Chevy Traverse Splash Guard - Rear
Please read instructions thoroughly before starting.
Tools Required
T15 Screw Driver
Drill
13/64" (5.0mm) Drill Bit
1/4" (6.35mm) Drill Bit
Awl
Clean Cloth/Rag
Package Contents
Description
Left Hand Splash Guard
Right Hand Splash Guard
Left Hand Splash Guard Bracket
Right Hand Splash Guard Bracket
M4.2 x 20 Screw with Washer
M4.2 x 25 Screw
M4.2 U-Nut
Instruction Sheet
NOTE: Do not use power tools to install splash guard fasteners.
Installation Procedure
1. Remove rear tire.
2. Clean and degrease body panel where splash guards are to
be located.
3. Remove existing screws at location (A) and (B) and retain.
See figure 1.
4. Place supplied bracket to vehicle and reinstall screws at
locations (A) and (B). See figure 2.
5. Drill 1/4" (6.35mm) hole at locations (C) and (D). Drill through
bracket and wheel liner. See figure 2.
6. Remove bracket and place supplied u-nuts onto bracket at
locations (C), (D) and (E). See figure 3.
7. Reinstall bracket to vehicle. See figure 2.
8. Place splash guard to bracket taking care to remove any
gaps to the vehicle and install supplied M4.2 x 20 screws w/
washer at locations (C), (D) and (E). See figure 4.
9. While pulling splash guard rearward and inboard to insure
no gaps, drill a 13/64" (5.0mm) hole at location (F). Drill hole
through splash guard and fascia. See figure 5.
10. Install supplied U-nut onto fascia at location (F) using an awl
to align the U-nut with the drilled hole.
11. Install supplied M4.2x25 screw at location (F). See figure 6.
12. Repeat procedure for the other side.
13. Guards can be cleaned with any commercially available
cleaner.
NOTE: Max torque on M4.2 Screw is 3.0 N m
Splash Guard - Rear
ALL INFORMATION WITHIN
DATE
ABOVE BORDER TO BE PRINTED
EXACTLY AS SHOWN ON 8.5 x 11 02NO16
WHITE 16 POUND NON-BOND
RECYCLABLE PAPER.
PRINT ON BOTH SIDES, EXCLUD-
ING TEMPLATES.
TO BE UNITIZED IN ACCORDANCE
WITH GM SPECIFICATIONS.
Quantity
1
1
1
1
6
2
8
1
REVISION
Initial Release - Michael Erickson
FIGURE 1
EXISTING
SCREWS
C
FIGURE 3
D
E
FIGURE 5
DRILL HERE
IR 02NO16
INSTALLATION INSTRUCTIONS
AUTH DR
TITLE
2579175
23257027
PART NO.
A
EXISTING
SCREWS
B
M4.2 x 20
SCREWS
U-NUT
F
M4.2 x 25 SCREW
23257027
PART NO.
Splash Guard - Rear
SHEET
FIGURE 2
C
DRILL
HERE
A
D
DRILL
HERE
B
FIGURE 4
C
D
E
FIGURE 6
U-NUT
(ALIGN
WITH AWL)
F
1 3
SHEET OF
1 3
OF