Cosatto NITTY GRITTY WOOP Manual De Instrucciones página 6

18 - fitting the raincover (older child mode)
Open the zip at the bottom of the raincover(a).
Starting from the foot end of the seat unit (b & c), fit the raincoover over the seat unit as shown.
Fasten the zip (d) at the rear of the raincover to secure the raincover.
There is zip located at the front of the raincover (e) for access to your child.
19 - fitting the Hold car seat (purchase separately)
Note: The car seat mounting adaptors are supplied with the Woop TS.
Fit the mounting adaptors to the mounts on each side of the pushchair chassis (a). Push down until
the tabs locate in the holes on the mountings (b).
Note: The mounting adaptors are handed. Dots are marked on the seat mounts and mounting
adaptors (c). These should be on the same side if fitted correctly.
To remove the mounting adaptors press the buttons (d) on the side and lift the mounting adaptors
off the mounts on the pushchair chassis (e). Store the mounting adaptors in a safe place for future use.
Place the car seat on to the mounting adaptors on each side of the chassis. Push down until the
car seat locks in place (f).
To remove the car seat press the release buttons (g) on each side and lift the car seat off the
pushchair chassis (h).
care
Your pushchair has been designed to meet safety standards and with correct use and maintenance
will give many years of trouble free performance.
The chassis is strong but will weaken should the back wheel be bumped down stairs or kerbs.
Continual impact will cause damage.
If your child wears hard shoes these might damage the soft fabric.
Store your pushchair in a dry, safe place.
Storing a damp pushchair will encourage mildew to form.
After exposure to damp conditions, dry off with a soft cloth, open fully and allow to dry
thoroughly before storing.
Do not leave the pushchair in sunlight for prolonged periods - some fabrics may fade.
maintenance
This pushchair requires regular maintenance by the user.
Regularly inspect the locking devices, brakes, wheels, harness assembly, catches, seat adjusters,
joints and fixtures to ensure they are secure and in full working order. They should be free to move
at all times.
Cosatto products are designed to operate with minimum maintenance, however regular lubrication
of moving parts will extend the life of your pushchair and make opening and folding easier.
Should parts of your pushchair become stiff or difficult to operate, apply a light application of a
spray lubricant e.g. silicone. Do not use oil or grease.
Wheels are subject to wear and should be replaced if necessary.
Your pushchair should be serviced and reconditioned before using it for a second baby, or after 18
months, whichever is the sooner.
cleaning
The hood may be cleaned by sponging lightly using warm water and a mild detergent.
Plastic and metal parts may be sponged clean with warm water and a mild detergent.
Never clean with abrasive, ammonia based, bleach based or spirit type cleaners.
For wash care instruction of the soft goods please refer to their respective wash care labels.