Audio Adjustments; Introduction Of Audio Adjustments; Setting The Sound Focus Equalizer (Sfeq) - Pioneer Super Tuner III D KEH-P7035 Manual De Instrucciones

Audio Adjustments

Introduction of audio
adjustments
1 Audio display
Shows the audio adjustments status.
% Press AUDIO to display the audio func-
tion names.
Press AUDIO repeatedly to switch between
the following audio functions:
Fad (balance adjustment)EQ (equalizer
curve adjustment)Bass (bass)Treble (tre-
ble)Loud (loudness)Sub-W1 (subwoofer
on/off setting)/NonFad (non fading output on/
off setting)Sub-W2 (subwoofer setting)/
NonFad (non fading output setting)HPF
(high pass filter)SLA (source level adjust-
ment)ASL (automatic sound levelizer)
# When the subwoofer controller setting is only
S.W Control:EXT, you cannot switch to Sub-W1.
(Refer to page 31.)
# You can select the Sub-W2 only when sub-
woofer output is turned on in the Sub-W1.
# When the subwoofer controller setting is only
S.W Control:EXT, you can switch to the non fad-
ing output on/off setting. (Refer to page 31.)
# You can select the non fading output setting
only when non fading output is turned on in the
non fading output on/off setting.
# When selecting the FM tuner as the source,
you cannot switch to SLA.
# To return to the display of each source, press
BAND.
HHHHHHHHHHHHHH
1
Note
If you do not operate the audio function within
about 30 seconds, the display is automatically re-
turned to the source display.
Setting the sound focus
equalizer (SFEQ)
Clarifying the sound image of vocals and in-
struments allows the simple staging of a nat-
ural, pleasant sound environment. Even
greater listening enjoyment will be obtained if
seating positions are chosen carefully. FRT1
boosts the treble on the front output and the
bass on the rear output. FRT2 boosts the treble
and the bass on the front output and the bass
on the rear output. (The bass boost is the
same for both front and rear.) For both FRT1
and FRT2, H setting provides a more pro-
nounced effect than L setting.
1 Press SFEQ to select the desired SFEQ
setting.
Press SFEQ repeatedly to switch between the
following settings:
FRT1-H (front 1-high)FRT1-L (front 1-low)
FRT2-H (front 2-high)FRT2-L (front 2-low)
CUSTOM (custom)SFEQ OFF (off)
2 Press c or d to select the desired posi-
tion.
Press c or d until the desired position ap-
pears in the display.
LEFT (left)CENTER (center)RIGHT (right)
Notes
! If you adjust the bass or treble, CUSTOM
memorizes an SFEQ setting in which the bass
and treble are adjusted for personal prefer-
ence.
Section
07
23
En