LaserLiner DuraMax Manual De Instrucciones página 13

The ADS is not active following switch-on. Once the device has been set up, press the tilt button to
activate the ADS, enabling you to protect the laser from changes in position caused by the device being
disturbed by external factors. The tilt LED flashes to indicate that the ADS function is active; see the
diagram below.
The ADS does not activate the monitoring function until 30 seconds after the laser levelling
!
procedure has been completed (set-up phase). The tilt LED flashes every second during the
set-up phase and flashes more slowly when the ADS is active.
ADS function
ON
Adjustment phase
Sensor Automatic
Shutter function: Various segments of this unit's laser output can be separately shut off
in order to eliminate disturbing reflections and interference when multiple rotary lasers are
simultaneously in use at the construction site.
Anti-shake function: The electronic permanently levels the units even if these are moving.
For quick levelling, on vibrating surfaces and windy weather.
Transport LOCK: The device is protected by a special motor brake during transport.
Protection against dust and water – The device characterised by specific protection against
IP 66
dustand rain.
Space grids: These show the laser planes and functions.
auto: Automatic alignment / man: Manual alignment
auto
Horizontal levelling
DuraMax / DuraMax XPro
ADS active after
Rotation 30 seconds; tilt LED
begins flashes slowly.
ADS activation: press
the tilt button; the
tilt LED flashes every
second.
man x
X axis slope
man y
Y axis slope
External influence
The laser
remains
stationary as a
precaution, the laser
flashes and the tilt LED
is lit continuously.
GB 13