LaserLiner DuraMax Manual De Instrucciones página 15

Optional accessories: Commander 50
1
2
3
4
5
Horizontal levelling
– Horizontal: Position the device on a level surface or on a tripod.
– Press the "ON/OFF" switch
!
slope/man function LED off: Automatic alignment
– The device levels itself automatically to within a range of ± 5°. During the set-up phase, the laser
flashes and the prism head remains stationary. When levelling is complete, the laser lights up
continuously and rotates at maximum speed. Refer also to the sections about "Sensor Automatic"
and "ADS Tilt".
If the device has been placed on a surface with too much of a slope (more than 5°), there is a
!
warning sound, the prism head remains stationary and the laser starts to flash. The device must
then be placed on a more even surface.
Anti-shake function
This function enables you to use the device when it is still in the set-up phase.
The laser will continue to rotate whilst it is being aligned by the automatic
sensor. This makes device set-up easier, as it enables the laser to be set to
a required height by means of a crank tripod or a wall bracket, for example.
It also means that the laser can be used on vibrating surfaces and in windy
conditions. This function can be used in combination with the single slope
function and all laser modes except adjustment mode. The function is activted
via the anti-shake button: when it is pressed, the anti-shake LED flashes
quickly. IMPORTANT: Precision is adversely affected during the set-up phase.
DuraMax / DuraMax XPro
1
2
6
3
4
5
7
6
8
7
9
8
10
9
9
10
Rotary speed for selection,
0 / 150 / 500 rpm
Scan mode
Hand receiver mode
Adjustment mode: toggle
between X and Y axes
Cover for adjustment mode
buttons / battery compartment
Infrared signal emitter
Positioning button (rotate to the
left) / calibration mode: save
Positioning button (rotate to the
right) / calibration mode: axis
switch-over
Plus/minus buttons for setting the
inclination with the single slope
function and the manual slope
function
Adjustment mode enter button:
save new setting
auto
GB 15