LaserLiner DuraMax Manual De Instrucciones página 17

Slope function up to 5° – horizontal
This function deactivates the automatic sensor. To use the function, press the slope/man button.
The plus/minus buttons are used to re-adjust the slope by means of a motor. In the process the
X-and Y-axis can be adjust separately. Refer to the illustrations below.
DuraMax / DuraMax XPro
X axis
1
3x
Constant
illumination
Constant
illumination
Constant
illumination
Slope function > 5°
Steeper slopes can be set using the angle plate, which is
available as an optional extra (product ref. 080.75).
TIP: Allow the device to align itself automatically and set
the angle plate to the zero position. Then press the slope/man
button to switch the automatic sensor off. Finally, incline the
device to the angle you require.
!
slope/man function LED lights up continuously: manual alignment
DuraMax / DuraMax XPro
X/Y axis
switch-over
2
± 5°
Constant
illumination
Constant
illumination
Constant
illumination
Commander 50
Y axis
3
Constant
illumination
Constant
illumination
Constant
illumination
4
± 5°
Constant
illumination
Constant
illumination
Constant
illumination
man
GB 17