LaserLiner DuraMax Manual De Instrucciones página 18

Shutter function (DuraMax XPro only)
The working area of the laser beam can be divided
into segments. The individual segments of the laser
beam can be also switched off. This feature is
important if multiple rotary lasers are being used
on the construction site.
Switch on the rotary laser and set it to hand
receiver mode in order to reach the maximum
speed of 500 rpm.
The segments are switched off using the minus
button and switched on using the plus button. The LEDs of segments that are switched off light up.
The segments can be rotated using the positioning buttons. This enables the segments that are
switched on to be moved into the required position without the need to adjust the laser.
Laser modes
Rotary mode
The following speeds can be set using the rotary button:0, 150, 500 rpm
Spot mode
You access spot mode by pressing the rotary button repeatedly until
the laser stops rotating. The laser can then be positioned exactly at the
measuring point by means of the direction buttons.
Scan mode
The scan button can be used to activate and set a lightintensive segment
in 4 different widths. You position the segment via the direction buttons.
Hand receiver mode
Working with the laser receiver (available as an optional extra): Set the
rotary laser to maximum speed and switch on the laser receiver. Refer to
the operating instructions for the respective laser receiver about this.
18 GB