CASUALPLAY MULTI FIX Manual De Instrucciones página 20

Idiomas disponibles

NOTE: Make sure that the seat belt straps are not twisted.

• If you want to fasten the ISOFIX connectors to the vehicle seat, and if this is possible,

follow the steps below.

NOTE: Consult the instruction manual for your vehicle to locate the ISOFIX anchors in the

vehicle, and to see which seats are fitted with them..

• Pull the ISOFIX connector adjustment, found under the upholstery of the seat, to take

the ISOFIX connectors out as far as they will go. Make sure that the ISOFIX connector

release buttons are unlocked (fig.21).

• Place the headrest of the MULTI FIX in its highest position.

• Position the MULTI FIX on the vehicle seat, facing forwards (fig.19).

• Fasten the ISOFIX connectors to the vehicle seat. They will click and a green signal will

appear on each of them when they are correctly fastened (fig.22).

• Fit the safety seat against the backrest of the vehicle seat, by pulling the ISOFIX connector

adjustment while pressing the safety seat against the vehicle seat (fig.23).

• Place the child in the MULTI FIX.

• Take hold of the buckle of the car seat belt. Pass the diagonal section through the guide

(coloured red) found on the headrest, and the abdominal section through the two guides

(marked red) on the sides (fig.20).

• Fasten the seat belt buckle. Adjust the height of the headrest so that the diagonal section

of the car seat belt passes over the child's chest, not his neck. And make sure the

abdominal section passes over the child's legs.

• To take the child out of the MULTI FIX, unfasten the seat belt buckle and take it off.

• If you want to remove the MULTI FIX from the vehicle seat, release the ISOFIX connectors

using the release buttons (if you have anchored the seat using the ISOFIX anchors).

Maintenance

• Take the upholstery off for washing. The fabric parts should be washed as indicated on

their attached care labels.

• Regularly inspect the child car seat.

• The plastic parts should be cleaned using a cloth with warm water and mild soap...